| 型號 | 品牌 | 功能應用 |
|---|
| MAX6317HUK41AZ-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 4.100V, min reset timeout 1ms, typ watchdog timeout 25.6sec |
| MAX6318LHUK47CY-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input, reset output active-low, push/pull; active-high,push/pull).Factory-trimmed reset threshold (typ) 4.700V, min reset timeout 140ms, typ watchdog timeout 1.6sec |
| MAX536ACWE | MaximIC | Calibrated, quad, 12-bit voltage-output DAC with serial interface. +-1LSB total unadijusted error. INL (LSB) +-1/2 |
| MAX8211CSA | MaximIC | Microprocessor voltage monitor with programmable voltage detection. Define output current limit. |
| MAX4532CAP | MaximIC | Low-voltage, CMOS analog ICs configured as three single-pole/double-throw switch. |
| MAX6307UK41D4-T | MaximIC | Multiple-input, programmable reset IC (open-drain reset output,factory-set reset threshold on Vcc,1additional undervoltage reset input,negative/overvoltage reset inp.).Factory-trimmed reset thresholds3.998(min),4.203(max).Nominal timeout period 1120ms. |
| MAX543BC/D | MaximIC | CMOS, 12-bit, serial-input multiplying DAC. Linearity (LSB) +-1 |
| MAX319EJA | MaximIC | Precision, CMOS analog switch |
| MAX187BEPA | MaximIC | +5V, low-power, 12-bit serial ADC. Error(LSB) +-1. |
| MAX6310UK44D2-T | MaximIC | Multiple-input, programmable reset IC(push/pull reset output,factory-set reset threshold on Vcc,1 additional undervoltage reset input,negative overvoltage reset input).Factory-trimmed reset thresholds 4.270(min),4.490(max). Nominal timeout period 20ms. |
| MAX6317HUK39AW-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-high, push/pull).Factory-trimmed reset threshold (typ) 3.900V, min reset timeout 1ms, typ watchdog timeout 6.3ms |
| MAX6316MUK49AX-T | MaximIC | Microprocessor supervisory circuit with watchdog and manual reset (watchdog input,manual reset input,reset output active-low,bidirectional).Factory-trimmed reset threshold (typ) 4.900V, min reset timeout 1ms, typ watchdog timeout 102ms |
| MAX6192AESA | MaximIC | Precision, micropower, low-dropout voltage reference. Output voltage 2.500V, initial accuracy +-2, temperature coefficient <5ppm. |
| MAX427EPA | MaximIC | Low noise, high-precision op amp. |
| MAX3317EEAP | MaximIC | +-15kV ESD-protected, 2.5V, 1microA, 460kbps, RS-232 compatible transceiver. |
| MAX1259CWE | MaximIC | Battery manager |
| MAX481ECPA | MaximIC | +-15kV ESD-protected, low-power, RS-485/RS-422 transceiver. Half-duplex. Data rate 2.5Mbps. Slew-rate limited - no. Low-power shutdown - yes. Receiver/driver enable - yes. Quiescent current - 300 microA. Number of transmitter on bus - 32. |
| MAX6314US43D4-T | MaximIC | 68H11/bidirectional-compatible microprocessor reset circuit. Reset threshold(nom) 4.30V. Reset timeout period(min) 1120ms. |
| MAX809ZEXR-T10 | MaximIC | Microprocessor reset circuit. Reset threshold 2.32V. Push-pull active-high reset. 10k increments. |
| MAX604MJA | MaximIC | 3.3V or adjustable, low-dropout, low quiescent currrent, 500mA linear regulator. |
| MAX700EPA | MaximIC | Power-supply monitor with reset. |
| MAX6360MSUT-T | MaximIC | Dual-voltage microprocessor supervisory circuit with manual reset. Reset threshold 4.38V (Vcc5) and 2.93V (Vcc3). Active-low push-pull reset 3V. Watchdog timer. |
| MAX4662CPE | MaximIC | 2.5om, quad, SWPST, CMOS analog switch (four NO switches). |
| MAX6321HPUK31CY-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 3.080V, reset timeout(min) 140ms, watchdog timeout(typ) 1.6sec |
| MAX4450EXK-T | MaximIC | Ultra-small, low-cost, 210MHz, single-supply op amp Rail-to-Rail outputs. |
| MXD1005SA175 | MaximIC | 5-tap silicon delay line |
| MAX397C/D | MaximIC | Precision, dual 8-channel, low-voltage, CMOS analo0g multiplexer. |
| MAX5352BEPA | MaximIC | Low-power, 12-bit voltage-output DAC with serial interface. INL (LSB) +-1. +5V single-supply operation. |
| MAX1675EUA | MaximIC | High-efficiency, low-supply-current, compact, step-up DC-DC converter |
| MAX6321HPUK26AW-T | MaximIC | Microprocessor supervisory circuit with watchdog (watchdog input, reset outputs active-high, push/pull and active-low, open-drain).Factory-trimmed reset threshold(typ) 2.630V, reset timeout(min) 1ms, watchdog timeout(typ) 6.3ms |
